2015 JN0-360 Dumps VCE Latest Updated By Braindump2go Today

2015 Latest released Juniper Official JN0-360 Practice Exam Question Free Download From Braindump2go Now! All New Updated 340 Questions And Answers are Real Questions from Juniper Exam Center!

Exam Code: JN0-360
Exam Name: Juniper Networks Certified Internet Specialist SP (JNCIS-SP)
Certification Provider: Juniper

Keywords: JN0-360 Exam Dumps,JN0-360 Practice Tests,JN0-360 Practice Exams,JN0-360 Exam Questions,JN0-360 PDF,JN0-360 VCE Free,JN0-360 Book,JN0-360 E-Book,JN0-360 Study Guide,JN0-360 Braindump,JN0-360 Prep Guide

QUESTION 271
On an Ethernet segment, OSPF DROther routers from which type of adjacency with each other?

A.    Full
B.    2Way
C.    ExStart
D.    Exchange

Answer: B

QUESTION 272
Which statement is true about routing instances on Junos devices?

A.    Routing information cannot be shared between routing instances.
B.    Each routing protocol runs in a separate routing instance.
C.    Junos devices support only one routing instance.
D.    Each routing instance is a unique grouping of routing tables, interfaces, and routing protocol parameters.

Answer: D

QUESTION 273
To which OSPF state does a device transaction once it receives an initial hello packet?

A.    2Way
B.    Full
C.    ExStart
D.    Exchange

Answer: A

QUESTION 274
Click the Exhibit button. Which two statements are correct according to the output shown in the exhibit? (Choose two.)
 

A.    The peering session can pass inet-vpn routes.
B.    The peering session uses an altered route preference.
C.    The peering session is enabled for multihop support.
D.    The peering session is enabled for multipath support.

Answer: BC

QUESTION 275
Click the Exhibit button. Referring to the exhibit, which policy would be applied to the 75.217.12.10 neighbor?
 

A.    The my-statics policy would be applied.
B.    The my-aggregates policy would be applied.
C.    The my-specifics policy would be applied.
D.    The my-statics, my-aggregates, and my-specifics policies would be applied.

Answer: D

QUESTION 276
Click the Exhibit button. Referring to the exhibit, all interswitch links are configured as trunks supporting all VLANs. Host A sends a frame with an unknown destination MAC address to S2.
Which switches will receive this frame?
 

A.    S1, S3 and S4
B.    S1 only
C.    S1 and S3 only
D.    S1 and S4 only

Answer: C

QUESTION 277
Which table will a Junos-based MPLS ingress router first consult to determine the next hop for BGP routes reachable through an LSP?

A.    inet.1
B.    mpls.0
C.    inet.3
D.    inet.0

Answer: D

QUESTION 278
Which Layer 2 mechanism logically groups network nodes into separate broadcast domains?

A.    IS-IS levels
B.    OSPF areas
C.    VLAN
D.    IP subnets

Answer: C

QUESTION 279
Click the Exhibit button. Switch 1 and Switch 2 are configured to run MSTP. However, MSTP is not working. Referring to the exhibit, which two actions will correct the problem? (Choose two.)
 
 

A.    Configure interface ge-0/0/2 on Switch 2
B.    Correct the bridge-priority parameter to be identical on both switches.
C.    Configure revision-level 2 on Switch 1.
D.    Correct the configuration-name parameter to be identical on both switches.

Answer: CD

QUESTION 280
You are asked to configure a new LSP in your network. The new LSP must take a specific path using a given set of routers.
What must you do to accomplish this task?

A.    A named path must be defined and referenced as primary for the LSP.
B.    A named path must be defined and referenced as preferred for the LSP.
C.    A named path must be defined and given a low priority.
D.    A named path must be defined and given a high priority.

Answer: A


Latest JN0-360 Questions and Answers from Juniper Exam Center Offered by Braindump2go for Free Share Now! Read and remember all Real Questions Answers, Guaranteed Pass JN0-360 Real Test 100% Or Full Money Back!

http://www.braindump2go.com/jn0-360.html